My RagWing "Ultra-Piet" Site

Home
Rib laceing
Covering and Paint
Fuselage
Ribs
Spars
Wings
Wing Tips
Ailerons
Control horns
Stick and Bell Crank
Empennage
Landing gear
Engine
Contact Me
Ailerons

4/10/06
mvc-008f.jpg
control system..in wing... not in the plans

My good friend and neighbor, David, designed these aileron pulley and brackets for the aircamper..no worry of the cable slipping out. I like this better than the plans of running it above the wing.

7/01/05
mvc-004f.jpg

After the leading edge is wrapped, you can cut away the ailerons.

aleroncutloose.jpg
They need to be cleaned up for the aileron ply webbing to be installed.

1/25/03
aileronend.jpg
aileron2.jpg
1.5mm strips need to be glued onto the bottom.

Hole locations
holelocations.jpg

The hinge half that attaches to the wing can be drilled in the center, but the half that attaches to the aileron must be drilled near the bottom. If not, when you drill the holes in the aileron, you will not be able to get a washer and nut on the back side of it.

hingehole.jpg
This hole will have to be filled ..glad I didn't drill 'em all!