SPI Engineering & Foreign Trade Ltd.

Bringing High-Tech Solutions to Your Problems�

High-Tech Solutions have vital development for today�s industry problems. SPI is a scienfitic solution provider worldwide, in order to reach your specific requirements, please give a change to help you.

We have a good repputiation to serve you basic and complex solutions with our partners. Our QA Service and high stock capability will provide one stop shopping corner in the NET.

SpiVision infrared inspection thermography service and commercial type of infrared cameras, sen-sors, IR-Windows, Nightsight Devices,

SpiCor Corrosion Engineering tools, coupons, magnetic and electronic systems,

SpiNDT and Ultrasonic Test Devices for coating and thickness measurement,

MotoSafe Series early warning, insulation fault detectors,

SpiFiber Polypropylene fibers for concrete,

SpiTank Portable liquid storage tanks for waste and hazardous chemicals as well as water.

Above: This is an image of a Contactor obtained during a recent survey. With a temperature of 146.3 degrees it clearly shows a problem on the Centre phase. This was almost 50 degrees above the other two phases. Further investigation revealed a loose connection which had caused oxidization of part of the cable

What is Thermography?
Thermography is a non-contact temperature measurement technique. It's ability to measure temperature in a non-intrusive manner make's it one of the best industrial tool's available today. When used as a predictive maintenance tool it's uses are endless. Building surveys, electrical surveys, mechanical surveys, insulation surveys. These are all services we supply. Our prices are competitive and we try to be as flexible as possible

An infrared survey can detect a problem before it manifests itself into a costly failure. It is very common to find a loose wire that can be repaired for less than �100, but if it were allowed to fail, the cost could skyrocket to thousands of pounds for equipment, repair or replacement. One of the great things about conducting an infrared scan is the equipment doesn't need to be shutdown. In fact, it is preferable for the equipment to operate near full-load capacity. That way we can measure the severity of the fault with greater accuracy. Having a survey conducted prior to a scheduled outage will afford the opportunity to acquire any needed replacement parts ahead of time.
Examples of what can be scanned:

Electrical switch gear, breakers, bus connections, and contacts
Transformer connections
Mechanical couplings on rotating equipment
Process piping and heat exchangers
Compressor heads
Motor and generator connections, windings, feeders and exciters
Bearings
Friction in drive gears and drive belts
Refractory systems (e.g. boilers, kilns, molten material containment)
Steam traps and piping insulation
Tank levels and insulation problems
What do I get besides a pile of pictures?
The photos of the electrical system condition are only the starting point. You'll receive reports that can be tailored to your needs. Working with your personnel, we develop the specific information to be included in your report that can bring light to the severity of the situation.

Our reports include an image of the condition, both in infrared and visual light, our analysis as to why the condition exists and suggestions for correcting the problem.

Contacts:
Acibadem AYPIM 242 Istanbul 81020 Turkey
Tel : +90 216 325 94 99
Fax : +90 216 326 02 00

SEARCH: Tripod The Web