WinchLock II
BLACK MAX SERIES - MAXIMUM SECURITY |
INSTALLATION INSTRUCTIONS
STEP ONE
Lower spare tire for access to frame cross-member panel with winch mechanism mounted above. Locate the threaded ends of the two mounting bolts used to attach the winch mechanism to the frame cross-member as shown in picture at left. Position and attach the U-shaped bracket to the threaded end of the mounting bolt using the provided 3/8" locknut and flat washer as shown in picture at right.
|
STEP THREE
Raise the spare tire while guiding the lower end of lock bar through the lug hole least obstructed by the winch cable retaining plate in the center of the wheel. The lock bar must remain vertical as spare tire is returned to the full up/stored position.
SPECIAL BLACK MAX INSTALLATION INSTRUCTIONS:
(1)Remove the key from the lock cylinder. (2)Place the Black Max lock assembly over the end of the locking bar with the bar cover/seal end up. (3)Slide the lock assembly upward until the bar cover/seal is compressed in the tapered surface of the lug hole. (4)
Press in on the "Push To Lock" button with the lock assembly still held firmly against the wheel, to engage the dead bolt lock mechanism with the groove in the locking bar.