WinchLock II
BLACK MAX SERIES - MAXIMUM SECURITY |
ISUZA
INSTALLATION INSTRUCTIONS
STEP ONE Lower spare tire for access to winch mechanism and frame cross-member panel. Note the two flange head bolts used to attach the frame cross- member panel to the rear frame cross- member. Use a 15mm socket or box wrench to remove the left side flange head bolt. Using the same flange head bolt, position and install the U-bracket as shown in the picture at lower left. |
STEP TWO Install the lock bar through the holes in both legs of the U-bracket with the grooved end facing toward the rear of the vehicle, as shown in picture at left. Place the crimp-ring retainer in the groove and crimp closed with pliers. |
STEP THREE
Raise the spare tire while guiding the lower end of the lock bar through the lug hole least obstructed by the winch chain mounting plate positioned in the center of the wheel. Prevent spare tire from rotating to insure that the lock bar remains vertical, as spare tire is raised to the full up/stored position.
SPECIAL BLACK MAX LOCKING INSTRUCTIONS:
(1)Remove the key from the lock cylinder. (2)Place the Black Max lock assembly over the end of the lock bar with the bar cover/seal end up. (3)Slide the lock assembly upward against the tapered surface of the lug hole. (4)Press inward on the "Press To Lock" button while holding the lock assembly firmly against the wheel to engage the dead bolt lock mechanism with the lock bar groove.
UNITED STATES PATENTS
4794771 - D399122 - 6505488