WinchLock II BLACK MAX SERIES - MAXIMUM SECURITY |
SPARE TIRE THEFT PROTECTION
STEP TWO Place the U-bracket over the winch shaft, positioned with the round hole side of the bracket facing toward the right frame rail. Insert the short end of the lock bar through the round hole of the U-bracket. Holding the lock bar hortizonal, align the flat machined end of the bar with flat sided hole in the opposite side of the bracket.Push the bar through the bracket.Let the bar swing downward to vertical position which locks it into the U-bracket. |
STEP FOUR Raise spare tire allowing lower end of locking bar to pass through the lug hole the least obstructed by the winch cable retaining plate in the center of the wheel. The locking bar must remain vertical as spare tire is returned to the full up/stored position.
SPECIAL BLACK MAX INSTALLATION INSTRUCTIONS:(1) Remove the key from the lock cylinder. (2)Place the Black Max lock assembly over the end of the locking bar with the bar cover/seal end up. (3)Slide the lock assembly upward until the bar cover/seal is compressed in the tapered surface of the lug hole. (4)Push in on the "Press To Lock" button with the lock assembly still held firmly against the wheel, to engage the dead bolt lock mechanism with the groove in the locking bar.