WinchLock
STANDARD SERIES - HIGH SECURITY

SPARE TIRE THEFT PROTECTION

CHEVROLET-GMC-CADILLAC

Tahoe/Suburban/Avalanche - Yukon/XL - Escallade/ESV
2000-2003

INSTALLATION INSTRUCTIONS


STEP ONE
Lower spare tire for access to winch mechanism and frame member directly above. Locate the stamped round hole in the frame cross-member panel approx. six inches diagonally to the rear of the winch mechanism.


STEP TWO
Reaching over the top side of the frame cross-member, install the provided 3/8” bolt and flat washer down through the stamped hole. Place the U-bracket over the threaded end of the bolt using the locknut and second flat washer to secure the bracket. Install the U-bracket as shown, with the holes in both legs facing toward the winch cable and tighten the locknut.


STEP THREE
Install the lock bar through the holes in both legs of the bracket, with the grooved end facing away from the winch cable. Place the crimp-ring retainer in the groove and crimp closed with pliers.

STEP FOUR
Raise the spare tire while guiding the lower end of lock bar through the lug hole least obstructed by the winch cable retaining plate in the center of the wheel. The lock bar must remain vertical as spare tire is returned to the full up/stored position.

This lock is designed to install with the spare tire in the original factory position, valve stem up.

STEP FIVE
The PVC lock bar cover/seal is designed to center and hold the lock firmly against the tapered surface of the lug hole. Hold lock inverted with the PVC cover/seal end up. Place lock over the end of the lock bar. Slide lock upward against the tapered surface of the lug hole and rotate to engage lock mechanism with the lock bar groove.

RECORD KEY CODE NUMBER FOR FUTURE REFERENCE


Lubricate Grease Fitting Once A Year To Validate LIMITED LIFETIME CORROSION WARRANTY
DO NOT Use Lithium Base Lubricants


UNITED STATES PATENTS
4794771 - D399122 - 6505488

Back| |Main Page >

800/843-5701

www.motivelocks.com