WINCHLOCK
SPARE TIRE SAVER
STANDARD SERIES - BLACK MAX SERIES

SPARE TIRE THEFT PROTECTION

FORD-MERCURY-MAZDA

ESCAPE SUV - MARINER SUV - TRIBUTE SUV
2005-UP

INSTALLATION INSTRUCTIONS

STEP ONE Lower spare tire for access to the winch mechanism Attached to the body floor pan above. Locate the the U-shaped frame bracket extending down through the floor pan in front of the winch mechanism.


Attach the lock mounting bracket to the front side of the U-shaped frame bracket as shown in picture at left.

STEP TWO Assemble mounting hardware as shown in picture at right: (a)Lock Mounting Bracket (b)3/8x1" Hex Head Bolt (c)7/16 Locknut (used as spacer) (d)Flat Washer (e)3/8" Locknut - Position the lock mounting bracket against the U-shaped frame bracket as shown in picture at right.Tighten locknut to draw the the flat surface of the lock mounting bracket down securely against the frame bracket.

STEP THREE Install the lock bar through the holes in both legs of the U-bracket, with the grooved end toward the left side of the vehicle. Place the crimp-ring retainer in the groove and crimp closed with pliers.

STEP FOUR Raise the spare tire while guiding the lower end of the lock bar down through the lug hole least obstructed by the mounting plate attached to the winch cable in the center of the wheel.

This Lock Is Designed To Install With Spare Tire In The Factory Installed Position, Valve Stem Down.

STANDARD SERIES LOCKING INSTRUCTIONS: The PVC bar cover/seal is designed to center and hold the lock against the tapered surface of the lug hole. Hold lock inverted with the PVC cover/seal end up. Place lock over the end of the lock bar. Slide lock upward against the tapered surface of the lug hole and rotate to engage lock mechanism with the lock bar groove.

BLACK MAX SERIES LOCKING INSTRUCTIONS: (1) Remove the key from the lock cylinder.(2) Place the Black Max lock assembly over the end of the lock bar with the bar cover/seal end up. (3)Slide the lock assembly upward until the cover/seal makes contact with the tapered surface of the lug hole. (4)Press in on the "Push To Lock" button with the lock assembly still against the surface of the wheel, to engage the deadbolt lock mechanism with the groove in the lock bar.

RECORD KEY CODE NUMBER FOR FUTURE REFERENCE

Lubricate Grease Fitting Once A Year To Validate Limited Lifetime Corrosion Warranty
DO NOT Use Lithium Base Lubricants

UNITED STATES PATENTS
4794771 - D399122 - 6505488

Back||Main Page||email||Order Form

800/843-5701

www.motivelocks.com