WINCHLOCK
SPARE TIRE SAVER
STANDARD SERIES - BLACK MAX SERIES

SPARE TIRE THEFT PROTECTION

TOYOTA TACOMA PICKUP
1995-2004

INSTALLATION INSTRUCTIONS


STEP ONE Lower spare tire for access to winch mechanism and frame cross-member. Note that winch mechanism is mounted to the inside of the C-channel frame cross-member. Locate the stamped 5/8” x 7/8” oblong hole in the vertical side of the cross-member located between the left side of the winch mechanism and spare tire support bracket.

STEP TWO Place the 3/8” x 1” hex head bolt through the center hole in the U-shaped mounting bracket. Attach the U-bracket to the frame cross-member using the provided locknut and flat washers. Position the U-bracket with the open sides aligned vertically as shown in both of the pictures.

The smaller, P225/75R15 and P235/55R16 tire sizes require the U-bracket to be installed with the mounting bolt at the upper end of the oblong hole in the frame, as shown in the picture at left. Larger tire sizes require the U-bracket to be installed with the mounting bolt at the lower end of the oblong hole.

Place the lock bar through the holes in both legs of the U-bracket, with the grooved end facing toward the left side frame rail. Place the crimp-ring retainer in the groove and crimp closed with pliers.

STEP THREE Raise the spare tire while allowing the lower end of the lock bar to pass through the lug hole least obstructed by the winch cable retaining plate in the center of the wheel. The lock bar must remain vertical as spare tire is returned to the full up/stored position.

This Lock Is Designed To Install With The Spare Tire In The Original Factory Position With The Valve Stem Up.

STANDARD SERIES LOCKING INSTRUCTIONS: The PVC bar cover/seal is designed to center and hold the lock against the tapered surface of the lug hole. Hold lock inverted with the PVC cover/seal end up. Place lock over the end of the lock bar. Slide lock upward against the tapered surface of the lug hole and rotate to engage lock mechanism with the lock bar groove.

BLACK MAX SERIES LOCKING INSTRUCTIONS: (1) Remove the key from the lock cylinder.(2) Place the Black Max lock assembly over the end of the lock bar with the bar cover/seal end up. (3)Slide the lock assembly upward until the cover/seal makes contact with the tapered surface of the lug hole. (4)Press in on the "Push To Lock" button with the lock assembly still against the surface of the wheel, to engage the deadbolt lock mechanism with the groove in the locking bar.


RECORD KEY CODE NUMBER FOR FUTURE REFERENCE



Lubricate Grease Fitting Once A Year To Validate LIMITED LIFETIME CORROSION WARRANTY
DO NOT Use Lithium Base Lubricants


UNITED STATES PATENTS
4794771 - D399122 - 6505488

Back||Main Page||email||Order Form

800/843-5701
www.motivelocks.com