For all brands of super powerful discount pellet air guns, paintball guns etc., scopes, hunting supplies try "Eddie's Super Cool Discount Stuff", we also have a full line of outdoor gear.
Lube-less Chrony Test.
Some air gunners state that air guns work better with out lubes. So I decided to do some testing of own with a Chrony.
I took the air gun apart and checked the piston's seal and main spring and found
them to be in good condition, they were clean, no black mess, only brown oil.
There does seem to be a slight dis-alignment in the breech's barrel's cone
that goes in the breech's seal. I later checked and detected no air pressure
escapes from the breech. I took the pressure chamber, main spring, the piston
and it's seal and clean them with a degreaser, rinsed well with water. I dried
them very well with a lint free cloth and set them to dry out completely in the
wind. After insuring the parts were completely dry I put the air gun back
together with out any lube or oil what so ever.
Lube less shooting the B-3-1, no oil, no moly, no "S-50".
fps:
296.9
325.1
321.2
326.2
334.7
I then placed some "Slick 50" on the main spring and behind the piston
seal inside the chamber, turned it over to let the "S-50" enter the
inside the chamber behind the piston's seal for 10 minutes.
fps:
349.2
342.3
I then sprayed the main spring with Slick 50 Lube.
fps:
369.1
360.8
376.4
The Slick 50 Lube started to enter the chamber, cutting this test short, causing
a spray every time I shot that caused my Chrony to give errors. Slick 50 Lube is
a spray can product and is too thin and penetrates thru the sides of the
piston's seal.
I put in the chamber 4 drops of "Slick 50 Advance formula. I shot off the
mixture of "Slick 50 Lube" and "Slick Advance formula" with
6 shots and then I place 3 drops of "Slick 50 Advance formula" in the
pressure chamber again and shot off 3 rounds until the spray was gone.
fps:
369.3
379.8
383.6
386.5
397.6
404.6
401.3
400.7
395.7
400.2
I have lost 16 to 33 fps in the test, this could be due to the lube-less
shooting of the air gun, it must have worn down the piston's seal a little.
From this testing I have gathered that syn. seals need some lube, be it oil,
S-50 or moly, using these syn. seals with out any lube at all will cause fast
wear and will cause lost of power. Piston seal replacement will have to done
often. This is why all spring piston air guns come with lube in their pressure
chambers, to help avoid fast wear of the piston's seal.
I also found that the B-3-1 in .22 cal. can not compare with the B-4-2 in .22
cal., the B-4-2 beats the B-3-1 by a long run. The B-4-2 in .22 cal. gave
me 650 fps, that is 250 fps more than the B-3-1.
Sincerely,
Eddie
For all brands of super powerful discount pellet air guns, paintball guns etc., scopes, hunting supplies try "Eddie's Super Cool Discount Stuff", we also have a full line of outdoor gear.