Synchronous Electric Clock Motor - 

Standard available in two hand-shaft lengths.

• Well made movement 50 Hz (Cycles per second) 230/240v  3W
• Covered contacts and cable clips to comply with Safety Regulations.
• Hour and minute hand fittings are the same as the Hechinger Standard Quartz Movements. The centre seconds hand is a screw on fit (see H332 and H333).
• Centre fixing. 10 mm diameter Dial Hole required.  Integral hanging bracket

 Overall height 100 mm excluding the hanger. Diameter 65 mm and Depth 31 mm.

TT346/15 - 15 mm hand-shaft length.

TT346/23 - 23 mm hand-shaft length.

These units are now available with side hand-setting at an extra £5.00. Please ask for details.

Large selection of Clock Hands are available for Standard movement but read text carefully when making a selection, especially for the centre seconds hand which has to be a left-hand screw on type.

Synchronous Electric Clock Motor -

High Torque - Suitable for dials up to 30" in diameter.

•  Well made movement 50 Hz (Cycles per second) 230/240v  3W
• Covered contacts and cable clips to comply with Safety Regulations.
• Centre fixing. 10 mm diameter Dial Hole required .
• Extension hand setting rod can be supplied at extra cost.
• The ideal movement for large indoor clocks.      
• Can be used in outdoor clocks if the case and glass have been weatherproofed and sealed.

• TT435  Spindle length 35 mm
• Collets are supplied. For fitment of your own hands if required.

 We can supply a pair of tapered hands that are suitable for this movement at

additional cost. Dimensions below.

Baton XL, High Torque (EF)

Quartz Clock Hands - Euro Fitting (EF) - Baton - XL (High Torque)

• Black
• Euro Fitting (EF)                                                                   
• Minute length 225 mm
• Hour length 180 mm
• Width 10 mm
• Made in Germany

Collet Dimensions:

• Minute: 3.5 x 2.8mm
• Hour: Ø5.0mm

All measured from minute collet centre to hand tip. The hands are generic and are likely to require squeezing to fit.

Hands suitable for Dial of 30" diameter - 

Collets are supplied. For fitment of your own hands if required.