Procedures for coping existing Remote Control to RMC-600

1. Open cover of RMC-600
2. Place RMC-600 infront of existing control on a flat surface.(Keep away from metal table)
3. Press button from both unit simultaneously using two fingers from same hand.
4. While adjusting frequency:

• Holding on the button of both units for about 1 cm(approx.) apart.
• When both frequency are approaching, notice the LED will flash 3 times.
• Tune the frequency by using the enclosed screw driver (See Fig.1)
• Turn the frequency adjuster clockwise or counter clockwise so that the LED can now show the brightest position.
• Hold on and enlarge the distance (no more than 4 cm) of both unit. The LED of RMC-600 will become weakest. Turn the frequency adjuster clockwise or counter clockwise until the LED show the brightest position.

Caution : If LED fails to flash 3 times, the product design for three stage frequency adjustable, The jumper 1 was setting in the first stage, please remove jumper 1 from fist stage into second stage if above step can't reach desired frequency, and retry above step until reach desired frequency.

5. Code duplicate for each function key :

• For duplicate first function key on RMC-600, press both units until first key button at the same time until LED indicator flash 3 times (it indicates the code of the original control has been copied) you can copy up to four remote function control by following step above
• To copy other push button same remote, simply press buttons of both remote simultaneously and wait for the LED of RMC-600 to flash 3 times
• No further adjustment is required once the first button is successfully copied.
• To start using the RMC-600 please remove jumper 2 your RMC-600 is now operational.

IMPORTANT: Interference that may cause undesired operation, please keep away from harmful interference when duplicate.

• Intelligent Programmable Remote Control
• "Direct Duplication" of most commercial RF Remotes