Hope you get a kick out of this patch. It's a simple setup, but I use it quite a bit for moody, hard rock solos, in the style of Gary Moore or Carlos Santana.

PATCH NAME: Solo Verb 
Author: MikeO
Comments: I use a US Strat with a Seymour Duncan '59 (full size) bridge, Vintage Rail middle, and a Cool Rail neck. I like reverb on those long, singing notes during solos. By using the Boss EV5 plugged into the SUB EXP PED Input, you can blend in the reverb for bringing on feedback more naturally. I use the expression pedal strictly for volume control, and with the reverb up, I can emulate violin-like singing tones with it. 

PREAMP / SPEAKER SIM
Type: MS1959(I)
Volume: 100
Bass: 100
Middle: 100
Treble: 100
Presence: 100
Master: 60
Gain: High
Mic Setting: Center
Mic Level: 100
Direct Level: 0

CHORUS
Mode: Stereo
Rate: 25
Depth: 25
Pre Delay: 0.0ms
High Cut Filter: 4.00kHz
Effect Level: 25 

REVERB
Type: Plate
Reverb Time: 4.0s
Pre Delay: 0ms
Low Cut Filter: 200Hz
High Cut Filter: 4.00kHz
Density: 10
Effect Level: See Pedal Assign
MASTER
Master Level: 100
Master BPM: NA
Noise Suppressor Effect: On
NS Threshold: 50
NS Release: 50
Foot Volume: See Pedal Assign 

CHAIN
Chorus>Preamp>NoiseSuppressor>FootVolume>Reverb

EXP PEDAL: On
Target: FV: Level
Target Min: 0
Target Max: 100

CTL PEDAL: On
Target: Rv: On/Off
Target Min: Off
Target Max: On
Source Mode: Toggle

ASSIGN 1: On
Target: Rv: Effect
Target Min: 10
Target Max: 50
Source: SUB EXP PEDAL (If you don't have one, and don't mind giving up the EXP PEDAL as a volume pedal, you can reassign accordingly)
Source Mode: Normal
Active Range Low: 0
Active Range High: 127