Smart Byte Cube

DSW600 Mikobu	infact i have seen several different types of loaders this week and alot of them dislike the hughs models.Voltage is the means to fixing cards and after reading the document included with both my Acid storm and Lightning Storm I was on my way.That's why COP cards are almost dead today.

Clone Testing

Football Card
Thanks to the hardworking guys over at Viperplus they have managed to come out with a PPV cleaner for HU cards for DTV.In emulation you need to make a computer run fulltime with similar 3M software.i had absolutely no problem flashing the unit and programming a few cards with it.	732 Blackout	Decode Bins

Thanks to the MODS and members who helped us have some fun and solved some problems along the way.

A bootstrap is programmed in the factory.Data logger - a device that logs the data between a smartcard reader and a smartcard, in both directions, and sends it to the serial port of a PC.While the other units work great you can definately tell the difference when using this one from Iceman.

Instead of a bootable floppy disk, this machine runs off of firmware which is actually flashed onto a chip contained inside of the unit.H CARD = A card that has been used for awhile and it's been gradually replaced by the HU card.

I say hobby, because this is not just a matter of getting your card "fixed" and move on.I have to start out with saying i liked the one little feature they threw in which was the litte rubber legs on it.

DSW600 Mikobu

Simular to 99 loop as it is also designed to take card out of service.

Avoid these ppl like the bubonic plague...lord knows you dont want to catch it!From what I understand www.emulator1.com are going to have a different probe in the very near future that contains extra pins to allow you to be able to write to the TSOP.Emulation is usually a more advanced testing method for people who have mastered 3M and Activation type software.

CLEANERS = An individual or Co. that unloops cards.Unplug receiver from the power outlet for 2 full hours Depending on the capacitors used in your receiver, this will ensure that RAM has been totally erased Plug the unit back in (with the card still in it) It should re-initialize correctly and begin to play on channel 100 If not, then you will need to wait about 20 hours on channel 100 for the FIRMWARE upgrade Then RESET by unplugging again on this channel, unless it comes back on The IMPORTANT THINGS to know are the following.In August, Littleton, Colo.-based EchoStar reported a profit of $37 million, or 8 cents a share, reversing a loss of $6 million, or a penny a share, a year earlier and ahead of Wall Street's average forecasts.Programs for PC computers are, however, usually written in C++, Pascal or Visual Basic.