| Ppv Directv |
 |
| Smartmouse interfaces are used to update programmed COP cards, to communicate with standard ATR-smartcards, and can also be used to program the 2416 chip on Multimac2-cards, if no PIC-programmer able to program this chip is available.This is the actual antenna of the sat system.You may also try it with the card in instead of removed.Leave the IRD turned ON Find IC104 (24c32 EEPROM) on the printed circuit board Short out pin 6 to pin 4 (which is GROUND), or the chassis frame Continue to hold short Do a SOFT BOOT by pressing GUIDE and the DOWN button simultaneously on the IRD Hold the short for 20 seconds. |
| Scripts, bins, hex, eprom, clean, write, save, hash,ird are all common terms once you get started it will all make sense.Because these are private, these are considered safe to use on currently subscribed cards.Also, experimenting with the access card and loading all different types of software to the card can loop it. |
| New versions of WGTBETA are usually released slower than versions for Nordic and Multimac2.These models do not have a RESET button Remove your access card from the receiver Select Menu Select Setup Select Installation Select System Test Press right arrow to BEGIN TEST When test is complete, USING THE REMOTE, press the CHANNEL UP key three times rapidly, followed by pressing CHANNEL DOWN twice (you must do this quickly) A new screen labeled SECRET SYSTEM TEST will appear Press both the ACTION and POWER buttons on the remote at the same time. |
|
