The clutch packs were the most involved. There are many little rubber seals that need to be replaced.

The rear output shaft has many steel rings that need to be replaced. Remember to remove the governor and get the two rings under it.

Don't forget to replace the outer rubber seal around the outside of the pump face.

Here are the two valve bodies side by side. I bought a Turbo Action manual/automatic valve body to install. The new one is the shiny one on the left.

Here is the new vent installed.

Here is a side veiw of the vent.

Here is an inside view of the fitting. Make sure you keep the fitting flush with the inside of the case so you don't interfere with the front band.

---

Go to the FAQ page.
Go Home.