Now the fancy lattice (design from Joan Huff) we used on the back of the wedding egg we showed a while back and a lattice picture was in the (Aug./Sept.'99) EggShell Artist with a review Gary LeMaster did on E-Z On Design,which I developed. Because you asked for a tip and others have asked how we get lattice to all look the same.Mostly we use a lattice template (fig.1) applied with my E-Z On Design, but have been known to add parts by hand.......
1- Using a cutting wheel cut an X in all the squares....(fig.2) 2- Make sure all little squares have an X in the center of them.... (fig.2) 3 - using a flying saucer bit, cut the oval in the center of all 4 outer lines of each square of lattice....(fig.3) 4. using the bit of your choice round all the inside corners of the X in each square...... |