INSTRUCTIONS FOR MEASURING ROOSEVELT'S ELK

All measurements must be made with a 1/4-inch wide flexible steel tape to the nearest one-eighth of an inch. (Note: A flexible steel cable can be used to measure points and main beams only.) Enter fractional figures in eighths, without reduction. Official measurements cannot be taken until the antlers have air dried for at least 60 days after the animal was killed.

A. Number of Points on Each Antler: to be counted a point, the projection must be at least one inch long, with length exceeding width at one inch or more of length. All points are measured from tip of point to nearest edge of beam as illustrated. Beam tip is counted as a point but not measured as a point.

B. Tip to Tip Spread is measured between tips of main beams.

C. Greatest Spread is measured between perpendiculars at a right angle to the center line of the skull at widest part, whether across main beams or points.

D. Inside Spread of Main Beams is measured at a right angle to the center line of the skull at widest point between main beams. Enter this measurement again as the Spread Credit if it is less than or equal to the length of the longer antler; if greater, enter longer antler length for Spread Credit.

E. Total of Lengths of all Abnormal Points: Abnormal Points are those non-typical in location or pattern occurring below G-4. Measure in usual manner and record in appropriate blanks. Note: do not confuse with Crown Points that may occur in the vicinity of G-4, G-5, G-6, etc.

F. Length of Main Beam is measured from the center of the lowest outside edge of burr over outer side to the most distant point of the main beam. The point of beginning is that point on the burr where the center line along the outer side of the beam intersects the burr, then following generally the line of the illustration.

G-1-2-3-4-5-6-7. Length of Normal Points: Normal points project from the top or front of the main beam in the general pattern illustrated. They are measured from nearest edge of main beam over outer curve to tip. Lay the tape along the outer curve of the beam so that the top edge of the tape coincides with the top edge of the beam on both sides of point to determine the baseline for point measurement. Record point length in appropriate blanks.

H-1-2-3-4. Circumferences are taken as detailed for each measurement.

I. Crown Points: From the well-defined Royal on out to end of beam, all points other than the normal points in their typical locations are Crown Points. This includes points occurring on the Royal, on other normal points, on Crown Points, and on the bottom and sides of main beam after the Royal. Measure and record in appropriate blanks provided and add to score below.