Home
Page
Tail
& Grip Wires
Revolution
Lead Mould
Soft
Bait Applicator
Tidal
Software
HQI
Price List
Go
to Order Form
Contact
HQi Tackle
Photo
Gallery |
HQi's Soft Bait Applicator..
With peeler crab prices hitting an all time
high, why throw your bait away with poor presentation and masked hooks, leading
to either no bites or worse still, missed bites. Now with our soft bait
applicator, you can bait up in a fraction of the time you normally take, with a
presentable bait each and every time.
Why stop at peeler crab?? With you're soft bait
applicator, you can use mussels, queen cockles in fact any mollusk (Shellfish)
that is excellent as bait, but not previously possible to cast great distances
without the hassle of a 10 minute baiting session.
HQi's soft bait applicator even takes the
hassle out of cocktail type baits, mix and match, with only your imagination to
limit you.
Instructions for making your own as follows:
-
Cut a 4 inch (100mm) length of round dowel
(Broom handle will do nicely)
-
Cut a slit from the center of one end,
tapering to the outside of the opposite end. (Line will be held in the slit)
-
Enlarge slit at center end slightly (Large
enough to take the hook eye)
-
Next drill 3 holes the same size as
18gauge wire, starting at the bottom of the dowel below the center slit,
next 2 holes go level with the center of the dowel each side.
-
cut 3 lengths of stainless 18 gauge wire, approximately
5 inch(125mm) long.
-
glue each length of stainless into each
hole.
-
leave for the glue to set.
Instructions for use:
-
hook the bait as per normal
-
Lay the line in the slit, with the hook
eye pulled tight in the enlarged hole of the slit
-
You should now have the bait and hook
supported by the 3 wire prongs.
-
Starting at the eye end, wrap knit
in elastic around the bait, taking care to make sure that the hook point is
not masked.
-
slide baited hook of the prongs, by
gripping the prongs near the dowel, whole lot will slide easily off, firmly held
by the elastic.
-
After a bit of practice, you will find it
only takes a few seconds to wrap any bait perfectly every time.
If you wish to purchase on ready made, we
will supply one made in polished mahogany & stainless steel for £7.50.
|