|
Here are all the solder pionts you need to fit a NEO2 modchip. We recommend that this modification is performed only by persons with good soldering skills. Be careful not too apply much heat or too much solder when making each joint.
This info is for the uk ps2 SCPH30003 V4 Only Action Replay 2 / Game Shark 2 versions 1.41 will work with this model.
To use the EA Method follow these simple instructions.
1) Boot AR2 v1.4 while holding reset (as standard EA Method)
2) Choose Start Game - Without Codes - Let go of reset
3) The disc will now eject (its still spinning) and the Press X to continue screen appears
4) DO NOT PRESS X - Swap with your Backup
5) Press O + R1 + R2
6) The EA Method Unpatched Game will now load
NOTE: You do not need to solder PINS 3,5 & 6 if you are patching your EA METHOD games with the addzero patcher. These PINS are for the EA Method swap only.
Splice the wire from PIN 2 and connect -v to the board and +v to the chip.1uf (Micro Fara) 63v Electrolytic Capacitor. It is recommended that a small amount of electrical .insulation tape be used to wrap around the mod chip and capacitor to avoid any unwanted electrical contact with the PS2 during installation.
|
