[home] [description] [setup operation] [milling operation] [safety reminder] [knee-type] [face milling] [plain/slab milling] [4 other types] [machining time on knee/face milling] [machining time on plain milling] [feedback]

SAFETY RULES FOR MILLING MACHINES

Milling machines require special safety precautions while being used. Therefore, safety measures should always be kept in mind so as to avoid unnecessary accidents on-site and also to keep us alert and be in the right frame of mind to react swiftly and correctly in case of an emergency. Here are some useful tips and reminders for users to follow.

 

• Do not make contact with the revolving cutter.

   

• Place a wooden pad or suitable cover over the table surface to protect it from possible damage.

   

• Use the buddy system when moving heavy attachments.

   

• Do not attempt to tighten arbor nuts using machine power.

   

• When installing or removing milling cutters, always hold them with a rag to prevent cutting your hands.

   

• While setting up work, install the cutter last to avoid being cut.

   

• Never adjust the workpiece or work mounting devices when the machine is operating.

   

• Chips should be removed from the workpiece with an appropriate rake and a brush.

          [NOTE Chip rake should be fabricated to the size of the T-slots. (figure 8-2 below)]

 



 

• Shut the machine off before making any adjustments or measurements.

   

• When using cutting oil, prevent splashing by using appropriate splash guards. Cutting oil on the floor can cause a slippery condition that could result in operator injury.

[home] [description] [setup operation] [milling operation] [safety reminder] [knee-type] [face milling] [plain/slab milling] [4 other types] [machining time on knee/face milling] [machining time on plain milling] [feedback]