WORKING SAFELY IN CONFINED SPACES
Introduction:
·
Confined Space:
OSHA defines a Confined Space,
as one that has limited or restricted means of entry or exit, is large enough for employees to enter and perform their work,
and is not designed for continuous occupancy.
§ Permit-Required Confined
Space (PRCS):
Is a space that has one or
more of the following characteristics:
§ Contains or could contain
hazardous atmosphere.
§ Contains materials
that have the potential for engulfing the entrant.
§ Has an internal configuration
such as that an entrant could be trapped or asphyxiated.
§ Any other recognized safety
hazards.
The following types of facilities
are designated as confined spaces:
1.
Manholes
2.
Sewer lines or tunnels.
3.
Storage tanks
4.
Silos
5.
Underground utility vaults and storage.
6.
Boilers
7.
Pipelines.
8.
Pits
9.
Wells.
There are two types
of confined spaces:
§ Class I confined space:
This is
a permit-required confined space (PRCS) which, because of the nature of hazards or the location of the space, it is not feasible
or possible to render the space safe to enter without proper respiratory protection. Authorized personnel entering this type
of space must wear appropriate supplied air respiratory equipment.
§ Class II Confined space:
This is
a permit-required confined space, which, due to the nature of the potential hazard(s) or the location of the space, can be
rendered safe for an employee to enter without wearing respiratory protection.
This can
be accomplished through work practice such as continuous ventilation and air monitoring of the space.
The following are some of
the general categories of hazards, which may be encountered in confined space:
§ Atmospheric hazards.
§ Mechanical and Electrical
hazards.
§ General Safety (means of
access / egress, trips, slips falls, hot, cold, etc.)
§ Engulfment hazard.
§ Atmospheric Hazard:
Atmospheric hazards cause the most confined-space
related deaths and injuries .
Atmospheric
hazards generally cannot be seen, in most cases, it is too dangerous to assume that the sense of smell will serve as a “early
warning system” air monitoring is usually required if atmospheric hazards are suspected.
There are three general
classes of atmospheric hazards:
§ Oxygen deficiency
§ Combustible / flammable
materials
§ Toxic gases
A.
Oxygen Deficiency:
1. Humans can survive for weeks without food, days
without water, but only
few minutes without air.
2.
Air contains a mixture of gases but is composed
primarily of nitrogen (78%) and oxygen (21%).
3.
When levels of oxygen are reduced below 19.5%, serious health problem begins to
occur very quickly.
4.
Oxygen is consumed by a variety of chemical
processes:
-
Aerobic bacterial growth. (consume oxygen to live)
-
Oxidation of rusting of metals
-
Combustion and displacement by other gases. (welding and cutting torches)
Effect of Oxygen Deficiency
Oxygen
Content |
Symptoms |
Physical Effects |
18 – 23 % |
None |
None |
12 – 16 % |
Increased Pulse Rate |
Lack of “fine” co-ordination
in fingers and hands |
10 – 12 % |
Rapid Pulse Rate, Nausea, Headache |
Breathing defficulties, lack of co-ordination |
6 – 10 % |
- |
Complete lack of co-ordination, inability
to react to danger, loss of consciousness |
0 – 6 % |
- |
Death
|
Flammable/Combustible
Materials:
1. Flammable and combustible materials are of an important concern with regards
to fires and explosions in confined spaces.
(Hydrogen Sulfide, Carbon Monoxide,
acetylene, and Methane).
2. The proper mixture of fuel and oxygen varies from gas to gas, but explosion range
is defined as the area between the lower explosive limits (LEL) and the upper explosive limits (UEL).
3.
When the mixture is above the upper explosive limits, it can readily move into
flammable range with the addition of dilution air.
4.
Potential source of ignition that could be found in confined spaces include :
open flames, arcs from electrical equipment, hot surfaces, static electricity and frictional sparks.
§ Toxic Gas Hazards:
§ Toxic or poisons gases present
two kinds of risks in a confined space:
§ Irritation
§ Asphyxition
§ Irritation:
§ Many gases, existing in low
concentration in the air, are irritating to the body’s respiratory and nervous system.
§ Asphyxiants:
Any
gases which when present in high enough concentration, causes displacement of oxygen in the body.
§ Carbon Monoxide:
§ Carbon Monoxide is one of the
most common asphyxiants. It is produced by incomplete combustion of carbon fuels.
§ Carbon Monoxide kills by chemically
combining with the hemoglobin in red blood cells. This greatly reduces the ability of the blood to carry oxygen to the body
tissues and brain cells.
Carbon Monoxide Exposure
Effects
35 ppm |
Permissible Exposure Limit
Over 8 hour shift. |
500 ppm |
Slight Headache |
1000
ppm |
Confusion, nausea, discomfort. |
2000 ppm |
Tendency to stagger. |
2500 ppm |
Unconsciousness after 30 minute
exposure. |
4000 ppm |
Fatal in less than one hour. |
§ Hydrogen Sulfide:
§ This gas even more toxic than
Carbon Monoxide. It is produced through the decay of organisms and natural materials.
§ This colorless gas has a characteristic
rotten-egg odor at first smell; however after a short time the gas renders the olfactory nerve (which controls the sense of
smell) ineffective, and the worker are no longer smells the substance, and yet it causes serious bodily harm in higher concentrations.
Hydrogen Sulfide Exposure Effects
10 ppm |
Permissible Exposure Limit
Over 8 hour shift. |
50 - 100 ppm |
Mild eye and respiratory irritation. |
200 - 300 ppm |
Marked increase in eye and
lung irritation. |
500 – 700 ppm |
Unconsciousness/death after
30 minute exposure. |
1000 ppm or more |
Death within minutes. |
2- Mechanical/Electrical Hazards:
§ The unexpected movement
of mechanical equipment or the unexpected discharge of electrical equipment in a confined space presents a very hazardous
situation for anyone within the space.
§ Commonly encountered equipment
includes:
·
Blenders – Stirrers – mixers and agetators.
It is very importants therefore to ensure that
all mechanical and electrical equipment is locked out and tagged out when any work is to be performed in a confined space.
·
General Safety (Physical Hazards):
·
Exposure to higher environmental temperature during work
activities.
·
Exposure to corrosive substances which could cause irritation
to
unprotected skin.
·
Exposure to rats and other pests living in the area.
·
Poor or inadequate illumination.
·
Exposure to noise from the use of hammers, hydraulic
equipment.
·
Slips and falls on wet surfaces or resulting from broken or
oxidized
ladder rungs.
·
Means of access and egress.
·
Improper handling of tools and equipment can result in cuts
and
back injury.
·
Engulfment:
×
The movement or shifting of material within a confined space has
been
responsible for many injuries and fatalities.
×
Of particular concern are loose, granular materials which can act
like quick sand.
×
Silos with grain inside are prime example of this type of hazard.
×
Possibility of engulfment by flooding while working in a storm
sewer.
Written Entry Permit:
Before anyone can enter the
permit – required confined space (PRCS) to work, there must be a written entry permit, which will list the following:
q
Name/location of the Permit-Required Confined Space
q
Purpose for entering the PRCS.
q
Date and duration of entry.
q
Names of those entering.
q
Names of those attending on the outside.
q
Supervisor’s name.
q
List of the expected hazard.
q
Means by which you intend to isolate or control the hazards.
q
Conditions under which you deem it acceptable to enter(level of
oxygen,
combustible, toxic materials etc.)
q
Test results of hazards in the atmosphere in the PRCS before and
during
the entry.
q
Provisions for rescuing someone from the PRCS.
q
Communication methods such as phones, radios, hand signals etc.
to allow enterant and attendants to
communicate with each other.
q
Equipment needed, including all the personal protective
equipment,
harness, alarm systems ………
q
Other special precautions or considerations spesific to the
particular
space.
Monitoring for Hazards in
Confined Spaces:
-
Measuring and monitoring for atmospheric hazards is one of
the important things to remember when doing confined space work.
1.
Oxygen:
·
According to the standard, 19.5 % is the minimum and 23.5
%
is the maximum range for oxygen in PRCS.
2.
Combustibles:
·
Measure the percent of LEL and according to the standard,
the
acceptable level for any combustible is at or below 10% of
its
LEL.
3.
Toxic:
·
Measure the concentration of toxic substances which might
be
available and compare same with TLV.
·
The entrant:
·
No one can enter a permit-required confined space (PRCS)
unless
he is authorized. That means he has to be thoroughly
trained
and checked out by his supervisor, so he will know:
-
The hazards present in the space.
-
How to recognize symptoms of exposure to hazards.
-
How to maintain contact with the attendants on the outside.
-
What personal protective equipment, retrieval lines, and harnesses he will need
to stay safe in the space.
-
To leave the space if he thinks he is in danger or if an alarm goes off.
·
The Attendant:
·
Work in Permit-Required Confined Space will be monitored
by
an attendant who has been trained to:
-
Keep constant count of every person in the space.
-
Keep in contact with the workers in the space.
-
Recognize and monitor hazards.
-
Order evacuation if anything inside or outside the space looks dangerous for the
workers inside.
-
Call for help from trained emergency response team if anyone has to be rescued
from the space.
Entry Procedure:
Once the initial tests are
completed and determined to be within acceptable limits, work may proceed utilizing the following precautions:
·
At least two, and preferably three, employees will conduct all
work
operations in confined space. One employee will remain
outside
of the space to be available in case of an emergency.
·
This individual must be in direct communication with the
other
workers in the confined space, as well as have the
capability
to reach emergency response personnel.
·
A portable blower must be used at all times during confined
space
work activities to purge the area of possible
contaminated
air.
·
The blower intake must be located outside of the confined
space
and away from any operating internal combustion
engine
to ensure that fresh air is being supplied.
·
Continous monitoring of the atmosphere inside the confined
space,
and at any time the monitoring devices indicate the
presence
of toxic or flammable gases, or a decreased level of
oxygen,
employees are to evacuate the space at once.
·
Each worker in the space shall wear a safety harness attached
to
a tripod located outside of the confined spaces.
Emergency and Rescue Procedures
·
If someone has to be rescued from a confined space, that is
the
job of the rescue team.
·
The rescue team will Know how to :
-
Close off the area
-
Remove victims with harnesses or rescue equipment.
-
Use oxygen, CPR, and other rescue and first-aid techniques and equipment.
-
They will enter the confined space wearing a SCBA respiratory system.