Installation of the PsxChipUk Mod Chip
DisclaimerThis modification will void any remaining warranty on
your PS console. It involves fine pitch soldering and should be considered hazardous to your Psx.On your own head be. it
Before you touch your Playstation or chip it is advisable to connect youself to ground via an Esd earth strap.The first thing to do is to attach the wires to the relevent pins on the chip do this before opening the playstation
Removal of the Outer Case
- Turn unit over and remove the 6 screws.(5 on Pu-8)
- Turn unit right-side up, and lift the cover off.
Removal of the laser housing
- Disconnect the flexable PCB by pulling straight up on the black/golden ribbon cable
- Disconnect the power connector (3 grey + 1 white wire) by pulling straight up.
- Lift off laser housing.
Removal of the controller/memory card housing(NOT necessary on pu-18)
- Remove the two screws on either side of housing.
- Remove the 3 small screws which connect the housing cover to the metal plate.
- Disconnect the ribbon cable by pulling straight up.
- Lift off the controller/memory card housing.
Removal of the heavy metal bracket
- Remove connector from power supply to main board(pull straight up).
- Remove the (5 on pu-18 / 3 on pu-8) screws holding the bracket in place.
- Lift off the bracket.
Removal of the circuit board
- Remove the (5 on pu-8 / 3 on pu-18) screws along the top edge.
- Lift off the circuit board.
Now its time to take a deep breath and to steady your hand. The chip is attached via pins 1 , 5 , 6 and 8
The pin numbers start top left(Marked by small indentation) and end top right in anti-clockwise direction.
First flatten the chip by bending the wires upward until level with body of chip (use pliers on all legs along one side in one go)
Now attach the wires to the chip be carefull not to hold the iron on it too long AND USE A LOW WATTAGE IRON , trim off any excess leg.
Next follow the relevant wiring pictures for pin connections. Once you have soldered the relevant points use tape to insulate
the chip from the shielding (to stop any possible shorting)
Then reverse the disassembly instructions to reassemble the unit.
Psx Modification Order form
Mod Chip Order Form
Compatability List
Installation Instructions
Wiring Pictures Index
100X Wiring Page
55XX Wiring Page
700x Wiring Page
Some Questions answered