2 sides stacked on the wall.
I know..I should have taken some photos while it was on the table being glued up with all the cams and block.
I guess I'm getting lazy.
I ordered some plywood from B&D International. They have the GL-II in 30"x60" size. Their website is
in my links page. Sandy is the person you'll talk to on the phone. They are wonderful people, and beautiful too! Go take a
look at their site.
6/8/03 |
|
All the crossmembers were cut with a raidial arm saw with a stop set up to make sure they are the same length.
6/8/03 |
|
seat supports for stations 29 1/8 and 40 1/8 |
I cut the seat support bulkheads to the dimensions on the plans. The rear one was to large. I recommend building the
pieces as you need them, measuring as you go. These will be glued in next, then the bottom ply will be added.
6/8/03 |
|
view from the rear |
6/8/03 |
|
As soon as the bottom is on, I'll move the fuse over the center chalk line and block it into place. Then the tail will
be pulled together.
6/14/03 |
|
6/14/03 |
|
6/17/03 |
|
10/30/05 |
|
inside looking aft. |
|